![cisco power over ethernet testing procedure cisco power over ethernet testing procedure](https://www.cisco.com/c/dam/en/us/td/i/200001-300000/280001-290000/281001-282000/281180.eps/_jcr_content/renditions/281180.jpg)
- #CISCO POWER OVER ETHERNET TESTING PROCEDURE HOW TO#
- #CISCO POWER OVER ETHERNET TESTING PROCEDURE UPDATE#
This eliminates the cost for additional electrical cabling that is otherwise necessary for connected devices. In addition, with PoE, you do not need to provide wall power for each PoE enabled device. Support for PoE enables the system to power inline devices, such as IP phones, IP video phones, and wireless access points over standard copper cabling (Category 5, 5e, or 6 cabling).
![cisco power over ethernet testing procedure cisco power over ethernet testing procedure](https://www.test-meter.co.uk/media/magefan_blog/2019/07/blog-power-over-ethernet.png)
The amount of PoE power available depends on the PoE capabilities of individual power supplies. PoE is supported by all Catalyst 4500 series chassis and requires a PoE module and power supply. The Catalyst 4500 series switch provides Power over Ethernet (PoE) support for both Cisco Prestandard PoE and the IEEE 802.3af standard (ratified in 2003). Refer to the Cisco IOS Command Reference and related publications at this location: If the command is not found in the Catalyst 4500 Command Reference, it is located in the larger Cisco IOS library. Note For complete syntax and usage information for the switch commands used in this chapter, look at the Cisco Catalyst 4500 Series Switch Command Reference and related publications at this location: Enhanced Power PoE Support on the E-Series Chassis.Displaying the PoE Consumed by a Module.Displaying the Operational Status for an Interface.Configuring Power Consumption for Powered Devices on an Interface.This chapter contains the following sections:
#CISCO POWER OVER ETHERNET TESTING PROCEDURE HOW TO#
This chapter describes how to configure Power over Ethernet (PoE) on the Catalyst 4500 series switch. You must ensure that your installation site has enough power and cooling to accommodate the additional electrical load and heat introduced by PoE. Note Before reading this chapter, read the “Preparing for Installation” section of theĬatalyst 4500 Series Installation Guide.
#CISCO POWER OVER ETHERNET TESTING PROCEDURE UPDATE#
Configuring Flex Links and the MAC Address-Table Move Update Feature.Configuring Layer 2 Ethernet Interfaces.Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant.
![cisco power over ethernet testing procedure cisco power over ethernet testing procedure](https://image.slidesharecdn.com/whatispoweroverethernet102909-12629614219359-phpapp02/95/what-is-power-over-ethernet-102909-35-728.jpg)
Environmental Monitoring and Power Management.Configuring Cisco NSF with SSO Supervisor Engine Redundancy.Configuring Supervisor Engine Redundancy Using RPR and SSO.Configuring the Cisco IOS In Service Software Upgrade Process.Configuring the Switch for the First Time.